TO PROGRAM ON/OFF EVENTS
Step Key Description
1 PRG Display goes blank except for the Channel indicator
bars, which flash alternately to indicate that a channel
number key must be pressed.
2 C1/C2 Selects channel to be programmed. C1 or C2
Indicator bar energizes and E:01 (first event) is dis-
played.
3 #### # Enter time, then day of week for first event. Enter four
digits for time (e.g., 0900=9:00 AM). For day of week,
1=Sunday, 2=Monday, 3=Tuesday, 4=Wednesday,
5=Thursday, 6=Friday, 7=Saturday, 8=Holiday,
0=Daily.
If no events are desired on a particular day — for
instance, on Day 8 (the Holiday Program) — key in
0000 for the time and — in Step 4 below — select ON
or OFF for the entire day.
4 ON/OFF Selects an ON or OFF event. Colon signifies an ON; no
colon signifies an OFF.
This step is unnecessary if you have used the
Momentary Option, since all events become ON
events.
5 E Enters programmed event into memory. Next event
slot (E:02 - E:16) displayed.
6 Repeat Steps 3 - 5 for all events on one channel. The
control will automatically switch to E:01 on the other
channel. Repeat Steps 3 - 5.
7 RUN Restores normal operation. Time and day displayed.
Colon flashing.
26
To Next Page
Loading...
Need help?
General
