INSTALLATION - EC72
NEMA 1 Case Mounting
1. Press back on spring clip at right center of metal case. See Figure
2 at left. Lift control out and set aside.
2. Remove desired knockouts to provide wiring access.
3. Mount case in a vertical position using the mounting holes provid-
ed.
4. Replace control by inserting tabs on left side of front panel into
slots on left side of case. Push down and snap into place.
5. Connect an electrical ground to grounding terminal screw located
inside the metal case bottom. See Figure 2 at left.
11
To Next Page
Loading...
Need help?
General
