TO REVIEW OR CHANGE EVENTS
Step Key Description
1 PRG Display goes blank except for Channel indicator bars,
which flash alternately to indicate that a channel num-
ber key must be pressed.
2 C1/C2 Select channel to be reviewed. Selected Channel
Indicator bar will energize. The first programmed event
will be displayed. If the first event has not programmed
event will be displayed.
3 E Press repeatedly to review all 16 events for one chan-
nel, followed by all 16 events for the other channel.
4 CLR Press if any displayed time and/or day must be
changed.
5 #### # Enter correct time and day.
6 RUN Restores normal operation. Time and day displayed.
Colon flashing.
7 C1/C2 Switching of loads occurs only in the RUN mode. If an
event was scheduled to occur while you where
reviewing or programming information, the event will
not have taken place if you were reviewing or pro-
gramming during the entire minute that the event was
scheduled to occur. Press C1 or C2 to initiate override
if the status of either circuit is incorrect.
28
To Next Page
Loading...
Need help?
General
