To Review or Change Holidays
Step Key Description
1 HOL Date of first holiday (H:01) displayed.
2 E Press repeatedly to review single day holidays, H:01 -
H:12. Press again to review H:13 - H:15, indicating the
begin dates for both holiday durations. No colon will
appear for H:14 and H:16, the duration end dates.
Press again to review Daylight Savings Time dates.
3 CLR Press this key if you discover that any date is incor-
rect. The title of the cleared holiday (H:01 - H:16) or
Daylight Savings Time date (Spr or FaLL) will be dis-
played.
4 #### Enter correct month and date.
5 E Enters new date into memory and advances to next
holiday.
6 RUN Time and day of week displayed. Colon flashing.
7 C1/C2 Switching of loads occurs only in the RUN mode. If an
event was scheduled to occur while you were pro-
gramming, the event will not have taken place if you
were programming during the entire minute that the
event was scheduled to occur. Press C1 or C2 to initi-
ate override if the status of either circuit is incorrect.
32
To Next Page
Loading...
Need help?
General
