(9) Power indicator
[When the battery is connected.]
・Green light : Battery is charged.
The bed can be operated.
・Green flashing : Battery is not fully charged yet.
The bed can be operated.
・OFF : Weak battery, need to charge.
The bed cannot be operated.
[When the battery is not connected.]
・Green light : The power cable is connected.
The bed can be operated.
・OFF : The power cable is not connected.
The bed cannot be operated.
(8) Low height indicator
・OFF : Bed height is at the lowest position.
・Orange : Bed height is not at the lowest position.
Pressing two or more buttons simultaneously stops the adjustment. If you stop the
adjustment by pressing two or more buttons, remove your hands from all buttons and
then perform the adjustment again.
●When the TR/RTR button is selected with the head end raised and the DOWN button is
pressed, the movement stops when the bed becomes flat. To incline the bed further,
continue to press the DOWN button for more than 2 seconds.
●When the TR/RTR button is selected with the head end lowered and the UP button is
pressed, the movement stops when the bed becomes flat. To incline the bed further,
continue to press the UP button for more than 2 seconds.
●If the bed is used continuously, the bed cannot be operated for protecting electrical parts
from overheating. In that case, disconnect the power cable and the battery cable, and leave
the bed for more 1 hour. After that, connect the power cable and the battery cable, and press
the Hi-lo adjustment UP[↑] and DOWN[↓] buttons simultaneously for more 5 seconds to
reset the protect condition.
●If the Electric CPR button is pressed, at first the back section base and inclination bed
move to flat simultaneously. After the inclination angle of the entire bed is flat, the knee
section base moves to flat.
●When the power cable is not connected, all indicators go out 2 minutes after the last button
has been used. If any button is pressed, the indicators light up again.
To Next Page
Loading...
