Bulletin HY25-1806-M1/US
Owner’s Manual
252 Series
Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA
27
Dodge/Sterling/Ram Installation
Pre Installation Overview (Continued)
Under Vehicle Installation
1. To access the PTO aperture on the right
(passenger) side of the transmission, the exhaust
pipe will need to be removed. (Fig. 32)
2. To make this process easier the following information
is provided.
The front end of the exhaust pipe at the turbo
charger is secured with a V band clamp part number
52121895AB. It is tightened to a torque value of 150
inch pounds.
At the rear of the pipe the M10 x 1.5 nuts are torqued
to 43 lbs-ft.
The part number for the gasket that is located
between the front pipe and the catalytic converter/
particulate filter (if it is damaged or lost) is
52122213AB.
More specific instructions on removing and installing
the exhaust pipe are available in the Dodge Truck
service manual.
If there are any additional questions related to this
procedure please contact the Dodge Truck Body
Builder Hotline at (866) 205-4102 or
dodgebbg@dcx.com.
3. Install Power Take-Off as described on pages 7-10
of this manual.
Fig. 32
To Next Page
Loading...
