Parker 700 Series - Page 10

Bulletin 1531-001/USA
Pump/Motor Division
700 Series Service Procedure
Parker Hannin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 USA
10
Change for All 700 Series motors with 1" diameter shafts
and date codes through 091-96 (3/31/96)
Change: New seal kit and outputs for 700 Series, 1" diameter shaft motors
Summary: Starting 092-96 (4/1/96) all 700 Series motors will use the 1.25" diameter type "A" and "B" ange and
the same seal kit regardless of shaft diameter size.
Description Not Available Replace With
After 3/31/96
(1" Dia. Parts) (1.25" Dia. Parts)
"A" Flange (including seats) PA-2983-1 PA-2984-1
"B" Flange (including seats) PA-2983-2 PA-2984-2
1" Keyed Shaft 2970-0 SL019000
1" 6B Spline Shaft 2970-1 SL019011
25mm Keyed Shaft 2970-2 SL019002
78" 13T Spline Shaft 2970-6 SL019006
SK000202 Seal Kit for 1" type shafts prior to 092-96 (4/1/96)
SK000203 Seal kit for all other type 700 series
2270 Thrust bearing (required when converting from 2970-X)
2271 Thrust washer (required when converting from 2970-X)
NOTE: Replacement shafts for any fo the above mentioned motors manufactured on or before 091-6 (3/31/96)
must be ordered with a 1.25" type ange. The 1" diameter type anges wll no longer be available. Also, the 1.25"
diameter type thrust bearing 2270 and thrust washer 2271 must be ordered to complete the change over.