Parker ETH Series User Manual

Operating / Mounting instruction
Electromechanical Automation
We reserve the right to make technical changes. 15.01.20 15:12 192-550003N10 ETH ATEX December 2019
The data correspond to the current status at the time of printing.
Operating / Mounting instructions
ETH Electro Cylinder with ATEX
Parker High Force Electro Thrust
Cylinder
DOC
-0008-
01
192-550003N10 ETH
ATEX
December 2019

Parker ETH Series Specifications

General

Brand	Parker
Model	ETH Series
Category	Engine
Language	English

Summary

1. Introduction

1.1 Device assignment

Identifies the specific ETH electro cylinder models covered by this manual.

1.4 ATEX declaration of conformity

Details the EU declaration of conformity for ATEX compliance and relevant standards.

1.5 Introduction to ATEX

Introduces the ATEX directive, its scope, and key concepts like explosive atmospheres and zone classification.

1.9 For Safety Use

Covers essential safety information, general hazards, and safe operating practices for product use.

1.13 Planning of the ETH Electro Cylinder for EX-Environment

Guides the user through the planning process for integrating the cylinder into explosive environments.

2. Commissioning

2.1 Mounting

Provides comprehensive instructions and procedures for physically mounting the ETH Electro Cylinder.

2.2 Electrical installation

Covers the essential steps and considerations for the electrical setup and connection of the cylinder.

2.3 Motor/ gear assembly

Details the process of assembling and integrating motors and gearboxes with the cylinder.

3. Maintenance and service

3.1 Maintenance schedule

Outlines a schedule of regular maintenance tasks required for the cylinder.

3.2 Lubricating intervals and amount of lubricant for ATEX ETH- Electro Cylinder

Specifies the required intervals and quantities for lubricating the ATEX ETH Electro Cylinder.

3.3 Toothed belt

Covers the inspection, maintenance, and replacement procedures for the toothed belt.

4. Supply repair

5. Index