Operating / Mounting instruction
24 192-550003N10 ETH ATEX December 2019
In this chapter you can read about:
Mounting.......................................................................................................................... 24
Electrical installation ........................................................................................................ 29
Motor/ gear assembly ...................................................................................................... 32
Read safety instructions (see page 14) before taking into operation!
If no Parker drive is provided, attach your motor-gearbox combination according to
the instructions in chapter motor and gearbox assembly (see page 32).
Also observe the notes in the assembly instructions for the motor/gear unit
combination used.
The technical data of the individual components must always be respected.
Depending on the application, the operating company must provide for a suitable
separating safety fence. The access to the motion area of the ballscrew and
piston rod should be prevented during operation.
The sound may vary from cylinder to cylinder. It depends on the motor/gearbox,
different drive options or on the production series due to different production lots.
Different sounds do not provide any hint as to the lifetime of the cylinder.
Depending on the operating conditions (rotation speed, load, etc.) increased
surface temperature in the area of the drive may occur. When touching it during
operation slight injuries from burning may occur.
Don't touch the product during
When installing the HLR linear axes in your system, make sure that the deflection
stations and the carriage are accessible for maintenance purposes! Greasing
option see ETH catalogue (solutions.parker.com/ETH_support).
2.1 Mounting
In this chapter you can read about:
Mounting with mounting threads on the cylinder .............................................................. 25
Mounting with mounting accessories ............................................................................... 25
Mounting of the payload .................................................................................................. 28
Before carrying out any assembling work make sure the piston rod cannot move.
Therefore, de-energize the respective drives. The internal ballscrew drive is not
self-locking! Always take care, especially in vertical position of the ETH cylinder
that the piston rod must be secured against moving out
Do only use the appropriate mounting parts offered in the Parker product
catalogue for the respective mounting methods. These mounting parts are
especially designed for the ETH.
The cylinder housing must be mounted without tension or contortion.
The cylinder housing must be precisely aligned to the load direction of motion.
Occurring lateral forces on the cylinder must be taken into consideration.
To Next Page
Loading...
