Parker ETH Series - Default Chapter; Table of Contents

Parker EME
Device assignment
192-550003N10 ETH ATEX December 2019 3
Inhalt
1. Introduction ............................................................................................. 5
1.1 Device assignment .................................................................................. 5
1.2 Type identification plate .......................................................................... 5
1.3 Mounting explanation .............................................................................. 6
1.4 ATEX declaration of conformity ............................................................. 7
1.5 Introduction to ATEX ............................................................................... 8
1.5.1. Explosive atmospheres .....................................................................................8
1.5.2. Harmonized European ATEX Standard ............................................................8
1.5.3. Zone classification / device categories ............................................................9
1.5.4. Type of explosion protection ............................................................................9
1.5.5. Explosion subgroup ........................................................................................ 10
1.5.6. Temperature classes ....................................................................................... 10
1.5.7. ATEX and machinery directive ....................................................................... 10
1.6 ETH ATEX marking .................................................................................11
1.7 Applications in accordance with the Regulations ...............................12
1.7.1. Applications not in accordance with the intended use ............................... 13
1.8 Operator’s obligations ............................................................................13
1.9 For Safety Use .........................................................................................14
1.9.1. General hazards ............................................................................................... 14
1.9.2. Identifying Residual Dangers and Hazardous Areas ................................... 14
1.9.3. Working safely ................................................................................................. 14
1.9.4. Safety Instructions for the Company Using the System ............................. 15
1.9.5. Safety Instructions for Operating Personnel ................................................ 15
1.9.6. ATEX specific safety instructions.................................................................. 16
1.9.6.1 ATEX specific safety instructions.......................................................... 16
1.9.6.2 General safety instructions - ATEX ...................................................... 16
1.9.6.3 Product specific safety instructions....................................................... 16
1.10 Packaging, storage, transport ...............................................................17
1.10.1. Special notes on transport ............................................................................. 18
1.11 Terms of guarantee / warranty ...............................................................21
1.12 Conditions of utilization .........................................................................22
1.13 Planning of the ETH Electro Cylinder for EX-Environment .................23
2. Commissioning ..................................................................................... 24
2.1 Mounting ..................................................................................................24
2.1.1. Mounting with mounting threads on the cylinder ........................................ 25
2.1.2. Mounting with mounting accessories ........................................................... 25
2.1.2.1 Cylinder mounting with mounting plates or foot mounting
brackets ................................................................................................ 25
2.1.2.2 Screw tightening torques for the mounting of the customer’s ETH
cylinder .................................................................................................. 25
2.1.2.3 Accessory mounting - bearing block ..................................................... 27
2.1.2.4 Mounting the rod guide (option R) ........................................................ 27
2.1.3. Mounting of the payload ................................................................................. 28
2.1.3.1 Side Load .............................................................................................. 28
2.1.3.2 Mounting of the payload ....................................................................... 28
2.1.3.3 Mounting of force sensors .................................................................... 29
2.2 Electrical installation ..............................................................................30
2.2.1. Direction of the motor during extension of the cylinder ............................. 30