Parker ETH Series - IP65 Motor Mount Parallel

Parker EME
Motor/ gear assembly
192-550003N10 ETH ATEX December 2019 43
2.3.3.2 IP65 motor mount parallel
The cylinder is furnished with mounted parallel housing. The housing as well as the
motor flange which is fixed to the housing, must be sealed.
ETH032…080:
 Mounting the toothed pulley (enclosed) on the
motor shaft; see chapter motor/ gear assembly
eth032..080 (see page 32).
 Apply silicone sealing compound to the motor
flange pilot (e.g. Sista Silicone F109 Universal).
 Screw motor to motor flange (enclosed) see
chapter Motor/ gear assembly ETH032..080
(see page 32).
 Apply silicone sealing compound around bores
of the parallel housing
 Mount motor with motor flange to parallel
housing; see chapter Motor/ gear assembly
ETH032..080 (see page 32).
 Tension toothed belt; see chapter re-apply
toothed belt tension or readjust toothed belt
tension .
 Place seal (furnished with the cylinder).
 Place lid (furnished with the cylinder).
 Fix lid and seal to parallel housing
ETH100&125:
 ETH100&125 are delivered with motor flange
mounted and belt tensioned. There is a paper
seal between motor flange and parallel housing,
no need to seal with silicone
 Remove clamping bush (enclosed) from the
hollow shaft; see chapter Motor/ gear assembly
ETH100&125 (see page 39).
 Apply silicone sealing compound to the motor
flange pilot (e.g. Sista Silicone F109 Universal).
 Mount the motor on the parallel housing and
tighten the clamping bush; see chapter Motor/
gear assembly ETH100&125 (see page 39).
 Place seal (furnished with the cylinder).
 Place lid (furnished with the cylinder).
 Fix lid and seal to parallel housing
Figure 31: Flange prepared for
IP65
Figure 32: Parallel housing
ETH32..80 prepared for IP65
Figure 33: Place seal
Figure 34: Place lid