Parker LORD - Redress and Service Kits

UM1004 | MRO-00011 05/21 Rev.0 DCO-016875 6
6.0 REDRESS KITS
Certain components on the Isolator are intended to be replaced on a regular basis. These Items can be purchased as part
of a basic redress kit, see Table 4. Additionally, major metals are available for purchase - refer to the Y-63700-XX Part
Numbers listed in Table 3.
Table 4: Basic Redress Kits
Kit Number
Kit Description
Qty
Component Part Number
Description
J-28460-34
Axial Elastomer
Kit
4
J-28348-53
Bonded Compression Assembly
2
J-28348-45
Bonded Rebound Assembly
J-28460-68
Axial Redress
Kit
1
J-28460-36
Axial T-Seal Kit
1
Y-63700-58-1
Threaded Seal Piston
1
J-28460-66
Anti-Rotation Pin Service Kit, Long
1
Y-63700-138-2
Guide Band
1
Y-63700-164-1
Guide Band
J-28460-36
Axial T-Seal Kit
2
N031B085TP009
T-Seal – HNBR, Peek
J-28460-66
Anti-Rotation
Pin Service Kit,
Long
6
Y-63700-165-1
Anti-Rotation Pin
7.0 RECOMMENDED SERVICE KIT STOCK
Parker LORD recommends that certain service kit items be put in stock by the users of the Isolator to facilitate quick repair
or replacement of wear items. This section will detail the recommended kits and quantities that should be kept on hand.
Quantities of each kit are given per number of Isolators in service (see Table 5). For example, for each Isolator in service,
five (5) Redress Kits are recommended to be kept in stock. For some lower wear items, a single kit can support several
Isolators.
Table 5: Suggested Stock
Part Number
Short Description
Suggested Stock
Quantity
per Axial Isolator(s)
J-28460-34**
Axial Elastomer Kit
1
1
J-28460-68*
Axial Redress Kit
5
1
J-28460-36
Axial T-Seal Kit
5
1
Y-63700-103-1
Inner Member
1
2
Y-63700-161-1**
Anti-Rotation Sub
1
2
Y-63700-162-1**
Anti-Rotation Inner Member
1
2
**Alternative versions could be stocked in place.