Parker LORD - Disassembly and Assembly Procedures; Isolator Disassembly Steps

UM1004 | MRO-00011 05/21 Rev.0 DCO-016875 11
• Replace Items as required due to wear/wash
Purchase Axial Elastomer Kit [J-28460-34], and Axial Redress Kit [J-28460-68] to perform Level II Service.
11.2 Disassembly Procedure
1. Secure Outer Housing (Y-63700-104-1) in vise.
2. Remove Sealing Sub Assembly (J-28460-39) from Outer Housing [Joint A].
3. Loosen, but do not fully remove, Pin Catch (Y-63700-134-2) [Joint C].
4. Break Anti-Rotation Sub (ARS) (Y-63700-161-1) from Outer Housing (Y-63700-104-1) and remove [Joint B].