Chapter 2: Installing the PowerStation Installing the PA2 PowerStation
PA2 PowerStation User Guide 2-9
5 Tighten each of the mounting screws against the front of the
enclosure. PowerStations with 15” displays also use a nut with the
screw.
6 Depending on your display size, either torque down the screws to the
value indicated in the chart, above, or ensure the proper level of
compression for the gasket. Also refer to figure 2-4.
Caution: Do not over-tighten the screw/clamp assembly or you
may damage the monitor. However, under-tightening
may not guarantee a NEMA 4/4x seal.
7 Tighten the screws in a crosswise sequence to ensure a good seal
and prevent damage. You may see a small gap between the bezel
and the enclosure.
Figure 2-4: Mounting the Clamp
Compress gasket
by 50% for 10” units
Bezel
Backshell
10” PowerStation
mounting clamp
Figure 2-4b: Side View of a 10” PowerStation Mounted in an Enclosure
Figure 2-4a: Side View of a 10” PowerStation Mounting Clamp
To Next Page
Loading...