Parker PowerStation PA2 Series - Mounting the PA2 Powerstation

Chapter 2: Installing the PowerStation Installing the PA2 PowerStation
PA2 PowerStation User Guide 2-8
Figure 2-3Mounting Chart for PA2 PowerStations
Mounting the PA2 PowerStation
1 Slide the PowerStation into the cutout from the front.
2 Attach the mounting clamps, with their screws to the back of the unit
in the spaces provided. Ensure you use all the clamps included in
your assessories kit. Refer to the chart, above, to locate the number
of clamps in your kit.
3 The clamps secure to the unit using the sliding mechanism shown in
the chart and in Figure 2-4.
4 Insert the clamp into the wide end of the slot and slide it to the thin
end.