Chapter 4: Maintaining the PowerStation Performing Internal Maintenance
PA2 PowerStation User Guide 4-7
Figure 4-4: Replacing the USB Ground on the Backshell
Closing the PowerStation
1 Replace the USB ground on the inside of the backshell as discussed
on page 4-6.
2 Replace the backshell on the PowerStation, refer to steps 3 and 4 on
page 4-6.
3 Remount the PowerStation in the enclosure, refer to Installing the
PA2 PowerStation on page 2-7.
4 Reconnect the following cables:
• Power Input cable
• Ground cable
• any communication cables
• any keyboard and mouse cables
5 Turn on the PowerStation.
The USB ground is
replaced on the inside of
the backshell.
To Next Page
Loading...