Chapter 4: Maintaining the PowerStation Performing Internal Maintenance
PA2 PowerStation User Guide 4-6
Figure 4-2: Backshell Screws
4 Lift the backshell off of the PowerStation to expose the board.
You are now ready to perform any internal maintenance necessary.
Important: When you lift the backshell off of the unit the USB ground
comes off of the backshell. You may find it on the board,
similiar as shown below.
Figure 4-3: USB Grounding on PA2 unit
Simply replace the USB ground by clipping it on the inside of the backshell,
refer to Figure 4-4.
Remove these screws
from the back of the
PowerStation.
USB Ground
To Next Page
Loading...