page 4
3.1 Display Mode
Operating the instrument in the display mode, the actual pressure (ACT) will be displayed.
The actual readout will be shown with its corresponding unit.
MIN, MAX or FS-will be shown at the additional display line.
Display Description
bar-graph
The actual reading will be displayed graphical by pixels.
Pressure peaks are indicated by a separated highlighted pixel.
Refreshing rate 50 msec.
ACT
Actual reading
Refreshing rate 300 msec.
MIN/MAX Displays MIN-, MAX- or FS-range.
Refreshing rate 300 msec.
FS
Full scale range (e.g. 400 bar)
Units
Engineering unit
Battery
Battery level (5 Steps)
REC
REC flashes when data logging is operated (on Option)
x10
Reading multiplied by 10.
3.2 Menu Functions
Following set ups can be done within the MENU Function:
• Automatic switch off enable/disabled
• Selection of engineering units (bar/mbar/PSI/kPa/Mpa.)
By pressing the MENU key (2 sec.) the desired function appears.
Skip to next function by pressing MENU again.
Confirmation by pressing the „OK“ key.
The ServiceJunior returns into the display mode.
To Next Page
Loading...
