Parker Serviceman Plus - Hardware version; scope of delivery; updates; Updates - updating the instruments firmware

6 V1.0/02/12
Hardware version / scope of delivery / updates
2. Hardware version / scope of delivery / updates
The basic conguration of your measuring instrument includes the
following:
• "SCM-155-0-02": Connections for two Parker analogue sen-
sors
or
• "SCM-155-2-05": Connection for a CAN bus network for a
maximum of three Parker CAN bus sensors:
• USB power supply (5V 1A), including regional adapters
• USB cable
• USB ash drive
• SensoWin software (included in delivery)
• Printed instructions, electronic operating manual (on the en-
closed disk)
The "Accessories" Chapter includes more information about the
available accessories that are not included in delivery.
2.1 Updates–updatingtheinstrument'srmware
The user can keep the measuring instrument up to date by updat-
ing the instrument's rmware. The update process is described in
this section.
The current rmware version of the instrument is shown during
boot up.
Files with a *.FIMG extension are used for the update. These
les are copied to the measuring instrument. The USB ash drive
should be used to transfer the les.
1 Copy the le with the extension *. FIMG (without sub-folders)
directly from the PC to the USB ash drive. Then plug the ash
drive into the instrument while it is switched off.
2 Disconnect all sensors that may be connected to your measur-
ing instrument.
3 Turn the instrument on and wait until the message "NO SEN-
SOR" is displayed and the Save icon appears in the top bar.
4 Briey press the ON/OFF key.
5 Wait for the following to appear on the display: FIRMWARE
UPDATE
->
OK
6 OK will initiate the update: FIRMWARE UPDATE. Press Esc to
switch off the instrument without updating.
Register by sending your product information to SMP.Info@
Parker.com; you will then be automatically informed of any
future rmware updates.