Parker WVM Series - Manufacturers Details; Dryer Specifications and Delivery Scope

EN | Operating manual General information
6 WVM 45 -1450
General information
Manufacturer’s details
Parker Hannifi n Manufacturing S.r.l.
Sede Legale: Via Sebastiano Caboto 1, Palazzina “A” 20094 Corsico (MI) Italy
Sede Operativa: Gas Separation and Filtration Division EMEA - Strada Zona Industriale, 4
35020 S.Angelo di Piove (PD) Italy
tel +39 049 971 2111- fax +39 049 9701911
Web-site: www. parker.com/hzd
Dryer Specifi cations
Scope of delivery
Adsorption dryer, consisting of:
◊ 2 vessels  lled with desiccant
◊ 1 Heater
◊ 1 Vacuum pump
◊ 1 Electrical panel including control system
◊ 1 Key for electrical panel
◊ Piping and silencer
Supplementary documents (standard scope)
◊ Operating manual (i.e. this document)
◊ Operating manual of pertaining controller
◊ Operating manual of  tted vacuum pump
◊ Technical documents (see appendix):
— Dimensional drawing
— Process diagram
— Pneumatic diagram of the control air unit
◊ Wiring diagram
Notes on supplementary documents
Supplementary documents such as operating manuals for options or pertaining components
must always be heeded. They contain additional information, e.g. regarding maintenance,
and are therefore necessary for safe operation of the plant.
Notes on upstream and downstream fi lters
Upstream and downstream  lters are not contained in the standard scope of delivery of the
dryer. For this reason, the operator must install at least an upstream  lter. Please also heed
the notes regarding the intended use on page(10)
Warranty notes
In the following cases, the warranty become void:
◊ If aggressive media in the compressed air and in the environment cause corrosion damage
and functional faults on the dryer.
◊ If the dryer is used without prior approval and con rmation in writing by the manufactur-
er for purposes other than those speci ed in these operating instructions or contractually
agreed.
◊ If preset parameters (e. g. on the control system etc.) are changed without prior approval
and con rmation in writing by the manufacturer.
◊ If the dryer is transported or stored incorrectly.
◊ If the dryer is sited and installed incorrectly.
◊ If the dryer is repaired or maintained incorrectly.