Why is it difficult to start and keep the fire burning in my Parkray Stove?
If you're having trouble starting or maintaining a fire in your Parkray Stove, it could be due to low flue draught. It is recommended to speak to your installer. Alternatively, the wood you're using might have a moisture content exceeding 20%. Make sure to use dry, seasoned wood with less than 20% moisture.
Why does my Parkray DERWENT Stove have low heat output?
If your Parkray Stove isn't producing enough heat, it could be due to a low flue draught. It is recommended to speak to your installer for advice on a suitable flue system. Another cause might be wet wood, specifically if the moisture content is over 20%. To resolve this, ensure you're using dry, seasoned wood with a moisture content below 20%.
Why does my Parkray Stove have excessive fuel consumption?
Excessive fuel consumption in your Parkray Stove can be attributed to a high flue draught. It is recommended to speak to your installer. Also, using over-dry wood, such as construction timber or pallet wood, can cause this issue. Avoid these types of wood.
Why does my Parkray DERWENT Stove have a short burn time?
A short burn time in your Parkray Stove may be because the wood you are using has a moisture content over 20%. Ensure you are using dry seasoned wood with less than 20% moisture content. Insufficient fuel amount can also be the reason. Ensure you are using enough fuel.
What to do if my Parkray Stove is over firing?
Over firing in your Parkray Stove can be caused by a high flue draught. It is recommended to speak to your installer. It can also happen if the air controls are left fully open. Try closing the air control to reduce the output.
Why is there excessive smoke when I open the Parkray DERWENT Stove door?
If excessive smoke enters the room when you open the door of your Parkray Stove, this could be due to low flue draught. It is recommended to speak to your installer. Another potential cause is incorrect additional ventilation air entering the building. It is recommended to speak to your installer.
Why am I unable to control the fire in my Parkray Stove?
If you are unable to control the fire in your Parkray Stove, this may be due to a high flue draught. It is recommended to speak to your installer.
Why is my Parkray DERWENT Stove producing smoke and small flames?
If your Parkray Stove is producing smoke and small flames, the wood you're using might have a moisture content exceeding 20%. Ensure you use dry, seasoned wood with less than 20% moisture content.
What to do if there is continuous smoke spillage into the room from my Parkray DERWENT?
If there's continuous smoke spillage into the room while your Parkray Stove is in use, it indicates a blocked flue. Open all doors and windows to ventilate the room, and allow the fire to go out. Check the flue for any blockages. Do not reuse the stove until the problem has been identified. If you're unsure, it is recommended to speak to your installer.
To Next Page
General