Parkside Performance PABSP 20-LI A1 User Manual

7 GB/IE/NI
1 charger PABSP 20-Li A1-2-BS
1 carry case
1 set of operating instruction
Technical details
Cordless drill: PABSP 20-Li A1
Rated voltage: 20 V
Rated idle speed: 1st gear: n
0
0–500 rpm
2nd gear: n
0
0–2000 rpm
Chuck clamping
range: max. Ø 13 mm
Max. drill diameter: Steel: 13 mm
Wood: 38 mm
Battery: PABSP 20-Li-A1-1
Type: LITHIUM ION
Cells: 5
Rated voltage: max. 20 V
Capacit y: 2.5 Ah
Charger: PABSP 20-Li A1-2-BS
INPUT
Rated voltage: 100–240 V
~
Rated frequency: 50–60 Hz
Rated input: 95 W
OUTPUT
Rated voltage: 14,4 - 20 V
Rated current: 4 A
Charging time: Approx. 45 min
(2.5 Ah battery pack)
Approx. 90 min (5.0 Ah
battery pack)
Protection class: II /
(Double insulation)
Noise emission value:
Noise measurement value determined in accordance
with EN 60745. The A-rated noise level of the
power tool is typically as follows:
Sound pressure level:
= 73.8 dB(A)
Uncertainty K: K
= 3 dB
Sound power level:
= 84.8 dB(A)
Uncertainty K: K
= 3 dB
Wear hearing protection.
Vibration emission value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Screwing: Vibration emission value
a
h
: 0.69 m / s
2
Uncertainty K = 1.5 m / s
2
Drilling in metal: Vibration emission value
a
h,D
: 1.534 m / s
2
Uncertainty K = 1.5 m / s
2
Note: The vibration level specified in these instruc-
tions has been measured in accordance with the
standardised measuring procedure specified and
can be used to make equipment comparisons. The
specified vibration emission value can also be used
to make an initial exposure estimate.
The vibration level varies in ac-
cordance with the use of the power tool and may
be higher than the value specified in these instruc-
tions in some cases. Regular use of the electric tool
in such a way may cause the user to underestimate
the vibration. Try to keep the vibration loads as low
as possible. Measures to reduce the vibration load
are, e.g. wearing gloves and limiting the working
time. Wherein all states of operation must be in-
cluded (e.g. times when the power tool is switched
off and times where the power tool is switched on
but running without load). General power tool
safety warnings Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and /
or serious injury.
General power tool
safety warnings
Read all safety warnings
and all instructions. Failure to follow the war-
nings and instructions may result in electric shock,
fire and / or serious injury.
Save all warnings and instructions for
future reference. The term “power tool” in the

Parkside Performance PABSP 20-LI A1 Specifications

General

Voltage	20 V
Battery Type	Li-Ion
Max Torque	60 Nm
Chuck Size	13 mm
Speed Settings	2
Torque Settings	21 + 1 drill setting