Parkside 315641 - Checking the Charge Status of the Rechargeable Battery; Control Display On Charger; Recharging the Battery

19
IE
GB
• Chargethebatterybeforethersttime
of use.
• Torechargethebattery,onlyusea
charger belonging to the Parkside
X20VTEAMseries.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an original replace-
mentbatteryfromtheParksideX20V
Teamseries,whichcanbepurchased
from customer service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• Thewarrantyexcludesalldefects
caused by improper handling.
Checking the charge status
of the rechargeable battery
Thebatterychargestatusindicator(3)
signalises the state of charge of the battery
(4).
Pressthebutton(2)onthebattery.The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
 Onlychargethebattery(4)when
the red LED on the charge status
indicator(3)ison.
Recharging the battery
Allow a hot battery to cool before
charging.
 Onlychargethebattery(4)when
the red LED on the charge status
indicator is on.
 Thechargingtimewiththedual
charger is about 1 hour.
1. Removethebattery(4)fromtheappli-
ance, as necessary (see „Removing/
insertingthebattery“).
2. Insertthebattery(4)inthecharging
compartment of the battery charger
(5).
3. Plugthebatterycharger(5)intoa
mains outlet.
4. When the battery is fully recharged
unplugthebatterycharger(5)fromthe
mains.
5. Removethebattery(4)fromthecharg-
er(5).
Control display on charger
 Thedirectioninwhichtoreadthe
controldisplay(6)isfromthebot-
tom up.If the charger is connected
to the mains socket and no battery
is inserted, all LEDs will light up per-
manently.
An LED ashes:
Batter(ies)(4)empty
An LED lights up, a second LED ashes:
Batter(ies)chargedto1/3
Two LEDs light up, third LED ashes:
Batter(ies)chargedto2/3