Parkside PAS D5 - Changing Rotary Direction; Safety Lock; Changing Bits and Magnetic Bit Holder

32 GB
 Changing rotary direction
 Push through the rotation direction switch[5] to set the rotary
direction (Fig. C):
Switch pushed from Direction Direction indicator
Right
(b)
Tighten
screws
[2]
Left
(a)
Loosen
screws
[4]
 Safety lock
Set the rotation direction switch[5] to the middle position so that it
protrudes equally on both sides. The switch trigger
[7] cannot be
pressed in this setting.
 Changing bits and magnetic bit holder

Pull out the bit[]. Insert another type of bit into the bit
holder
[1] or the magnetic bit holder[] (Fig. D).
NOTE: Screw bits are labelled according to their dimensions
and their shape. If you are unsure, always try the particular
screw bit out to see whether it sits in the screw head without any
free play.