43GB
In particular clean the air vents after every use with a cloth and
soft brush.
The vents must always be clear.
NOTE
u Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might
be harmful to its surfaces.
Maintenance
Before and after each use: Check the product and the following
accessories for wear and damage:
–
[] Magnetic bit holder
–
[] Screw bits
–
[] Torque attachment
–
[] Eccentric attachment
–
[] Angle attachment
–
[] Cutting attachment
If required, exchange the accessories for new ones:
– see “Changing bits and magnetic bit holder”
– see “Replacing the cutting blade”
Observe the technical requirements of the accessories (see
“Technical data”).
To Next Page
Loading...
