Parkside PAS D7 - Page 21

19GB/IE/NI
o The marking on the torque
adjustment collet
[] indicates the 10
available torque levels. The length of
the screw icons
[] and the width of
the white colour bar
[] represent the
following torque:
10 9 8 7 6 5 4 3 2 1
Level T N 
1 0.44
2 0.48
3 0.53
4 0.60
5 0.65
6 0.70
Level T N 
7 0.78
8 1.20
9 2.30
10 3.40
o Listed driving torque value is
measured by static load test method.
This is the maximum torque to drive
the screw into wood corresponding
to level 1-10.
NOTE: These are approximate values
for reference only. Do not rely only
on this data when high accuracy is
required.
 Eccentric attachment
(Fig.H)
Use the eccentric attachment
[] for
tightening and loosening screws that are
close to the ceiling or an adjacent wall.
 Angle attachment
(Fig.I)
Use the angle attachment
[] for
tightening and loosening screws at an
angle of 90°.
 Cutting attachment
(Fig.J)
The cutting attachment
[] is designed
only for cutting soft materials. Examples:
– Corrugated paper (max. thickness:
5mm)
– Drapery
– Leather (max. thickness: 3mm)