Parkside PAS D7 - Cleaning and Maintenance; Maintenance

20 GB/IE/NI
m
CAUTION!
u An arrow symbol is marked on the
blade guard to indicate the saw
blade’s rotational direction. Cutting
operation can only be processed
by setting the saw blade to this
rotational direction. Make sure
the rotation direction switch
rotation
[5] is completely pushed
down from direction b before you
start cutting (Fig.C).
Replacing the cutting blade
(Fig.K)
m
CAUTION! When the saw blade[] is
to be removed from or inserted to the
blade guard, do not touch the sharp
cutting edge. To avoid injury, wearing
suitable protective gloves is required.
o Install the cutting attachment[] to
the product.
This prevents the spindle
[] from
rotating and allows the screw
[] to
be removed.
o Loosen the screw[] in a counter-
clockwise direction by using a PH2
or SL6 screwdriver (not included).
o Remove the screw[] from the
spindle
[].
o Hold the product in an upright
position. Swing it gently and allow
the cutting blade
[] to slide out
slowly from the blade guard (Fig.M).
o Insert a new cutting blade[] into the
cutting attachment
[] (Fig.N).
o Ensure the cutting blade[] is sitting
tight in the slot of the spindle
[]
(Fig.L).
o Tighten the screw[] in a clockwise
direction.
o The attachment is ready for use
again.
NOTE: Replacement cutting
blades
[] are available from OWIM.
 S 
S  Action
On Press the switch
trigger
[7] and hold
it in place.
The LED work
light
[8] lights up.
O Release the switch
trigger
[7].
The LED work
light
[8] goes o.
NOTE: You can use the LED work
light
[8]even when the product is
not in use. Set the rotation direction
switch
[5] to the middle position.
Switch the LED work light on/o
according to above description.
 Cleaning and maintenance
o Before cleaning or carrying out any
maintenance:
– Set the rotation direction switch
[5]
to the middle position. This
prevents unintentional switching
on.
– Remove the USB cable
[].
– Remove the bit
[], the magnetic
bit holder
[] or any of the
attachments
[] [] [] [].
– Disconnect the charger
[] from
the socket-outlet.
o Never allow uids to get into the
product.