Parkside PAS D7 - Storage; Transportation; Disposal

21GB/IE/NI
o The product must always be kept
clean, dry and free from oil or grease.
Remove debris from it after each use
and before storage.
o Regular and proper cleaning will help
ensure safe use and prolong the life
of the product.
o Clean the product with a dry cloth.
Use a soft brush for areas that are
hard to reach.
o In particular clean the air vents
after every use with a cloth and soft
brush.
o The vents must always be clear.
NOTE
u Do not use chemical, alkaline,
abrasive or other aggressive
detergents or disinfectants to
clean this product as they might be
harmful to its surfaces.
 Maintenance
o Before and after each use: Check
the product and the following
accessories for wear and damage:
–
[] Magnetic bit holder
–
[] Screw bits
–
[] Torque attachment
–
[] Eccentric attachment
–
[] Angle attachment
–
[] Cutting attachment
If required, exchange the accessories
for new ones:
– see “Changing bits and magnetic
bit holder”
– see “Replacing the cutting blade”
Observe the technical requirements
of the accessories (see “Technical
data”).
 Storage
o Set the rotation direction switch[5]
to the middle position. This prevents
unintentional switching on.
o Store the product in a dry indoor
location protected from direct
sunlight.
o Store the product in its carrying
case
[].
 Transportation
o This product contains a Li-Ion
rechargeable battery and is therefore
subject to hazardous materials
regulation. Users may transport the
product with built-in rechargeable
battery on roads or by sea without
special requirements.
o The packaging and marking is
subject to special requirements when
it is transported by third parties (e.g.
airline, courier, carrier). A hazardous
materials expert must be consulted
when transported by third parties.
NOTE: The integrated Lithium-Ion
battery may only be removed by
trained or qualied personnel.
To remove the battery from the
housing, the battery must be empty
and the screws unscrewed from
the housing. The connections on
the battery must be individually
disconnected and isolated.
 Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Observe the marking of the
packaging materials for waste
separation, which are marked
with abbreviations (a) and
numbers (b) with following
meaning: 1–7: plastics/20–22:
paper and breboard/80–98:
composite materials.