To Next PageTo Next PageWhy does the Parkside PKS 1500 A1 motor overheat easily?
To prevent the motor from overheating, avoid overloading it during cutting tasks. Additionally, make sure to regularly remove dust from the motor to ensure it cools properly.
What causes reduced cutting power when sawing with my Parkside PKS 1500 A1?
Reduced cutting power could be due to a saw blade that is too small or has been ground down too much. Readjust the end stop of the saw unit.
Why does the motor start up slowly and not reach operating speed on my Parkside Saw?
If the motor starts slowly and doesn't reach operating speed, it could be due to low voltage, damaged coils, or a burnt capacitor. Contact the utility provider to check the voltage. Arrange for a specialist to inspect the motor and replace the capacitor if necessary.
How to fix a rough or wavy saw cut with my Parkside PKS 1500 A1 Saw?
A rough or wavy saw cut can occur if the saw blade is dull or the tooth shape isn't right for the material thickness. Resharpen the saw blade, or use a more suitable saw blade.
What to do if the workpiece pulls away and/or splinters when using my Parkside PKS 1500 A1?
If the workpiece pulls away or splinters, it might be because of excessive cutting pressure or an unsuitable saw blade. Insert a suitable saw blade.
Why does my Parkside PKS 1500 A1 Saw motor make excessive noise?
Excessive noise from the motor could indicate damaged coils or a defective motor. Arrange for a specialist to inspect the motor.
What to do if my Parkside PKS 1500 A1 Saw motor does not reach its full power?
If the motor isn't reaching its full power, it could be due to overloaded circuits in the network, possibly from other motors or equipment. Try not to use any other equipment or motors on the same circuit.
Why does my Parkside Saw motor overheat easily?
The motor may be overheating due to overloading or insufficient cooling. Avoid overloading the motor during cutting tasks. Additionally, remove any dust from the motor to ensure it cools effectively.
General| Power | 1500 W |
|---|---|
| Blade Diameter | 190 mm |
| Cutting Angle | 0° - 45° |
| Weight | 4.6 kg |
| No-load speed | 5000 rpm |
| Cutting depth max. at 0° | 65 mm |
| Cutting depth max. at 45° | 45 mm |
| Cable length | 2 m |
| Max cutting depth at 90° | 65 mm |
| Cutting Depth | 65 mm |
| Saw blade | 190 mm |
Lists items included in the package for the mitre saw.
Provides detailed specifications such as dimensions, weight, and cutting capacity.
Details the noise levels (LDA, LWA) and vibration values during operation.
Covers keeping the work area orderly, environmental factors, and lighting.
Emphasizes protection from electric shock, keeping others away, and wearing suitable clothing.
Details correct usage, avoiding overloading, and using the right tool for the job.
Covers saw blade use, personal protective equipment, and dust collection.
Instructions on keeping tools sharp, checking cables, and avoiding inadvertent starting.
Guidelines for using insertion tools, speed, and saw blade condition.
Precautions for avoiding eye exposure to the laser beam.
Instructions on inserting, charging, and handling batteries safely.
Addresses potential hazards like electrical shock and excessive pressure.
Steps for unpacking, moving, transporting, positioning, and connecting the machine.
Details on installing dust bag, work piece clamp, and supports.
Defines intended and unintended uses, and cutting data.
How to pivot the table plate and tilt the saw unit.
Steps for fixing workpieces, cross-cutting, and replacing the saw blade.
Instructions for changing laser batteries and connecting the machine to power.
Information on dust extraction systems and general maintenance tasks.
