GB MT
68
Manually interrupting/
starting the operating cycle
Interrupting operation
Press the STOP button (9) to stop the mow-
er during operation.
Starting/resuming operation
1. Open the cover (1).
2. Confi rm the selection with the OK but-
ton (7).
3. Unlock the display (10) with the 4-digit
PIN (factory setting “1111”).
4. Press the start button (3).
5. Close the cover (1) again.
The lawn mower starts the set operat-
ing cycle or resumes its previous activi-
ty without interruption.
Connecting the device
with the Lidl Home App
1. Open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting “1111”).
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select “Set-
tings”.
5. Confi rm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select “Ac-
tivate WiFi”.
7. Enable Bluetooth® on your smart-
phone.
8. Open the Lidl Home App.
From here there are options
,
and
to connect the device.
If this is the device you wish to connect
to the app:
9. On the
tab, select the option “Add
device”.
The app scans the area for available de-
vices and indicates if available devices
have been found.
If this is not the case, read on if
possible
.
10. If you select "Go to add", the available
devices are displayed in a list.
11. Select the device by setting the check
mark
. Select only one device at a
time. If there are other check marks for
other devices, clear the check marks by
pressing them.
12. Now press the
, that has the same
colour as the set check mark.
13. Select your WLAN and enter the corre-
sponding password.
14. Confi rm the successful connection with
“Finish”.
The device is now listed in the
tab
and can be selected.
If you have already connected other
devices to the app:
9. On the
tab, select the in the up-
per right. The app scans the area for
available devices and indicates if avail-
able devices have been found.
If this is not the case, read on if
possible
.
10. Proceed as with
from point 10.
If a list of available devices is not auto-
matically suggested to you:
If the device is not suggested automatical-
ly, follow these steps:
9. On the
tab, select the in the up-
per right.
10. Select “Other” in the bar on the left.
11. Select “Other 2”.
12. Confi rm that the display is fl ashing rap-
idly.
To Next Page
Loading...
