To Next Page
T
tayloraprilJul 31, 2025
What to do if my Parkside PTBM 500 A1 doesn't start?
- LLaura MartinJul 31, 2025
If your Parkside Drill doesn't start, here are a few things to check: * First, make sure the emergency stop switch hasn't been triggered. Reactivate it by turning the switch, then press the on switch to restart the drill. * Next, check the socket, mains supply cable, cord, and mains plug. If there are any issues, have them repaired by a qualified electrician. Also, check the main fuse. * If these steps don't work, the on/off switch or the motor may be broken, and you should contact Customer Care for repair.
General
