21
GB MT
Operation
Working instructions
Weed killer
remove weeds.
is the spring.
the plant is still young.
will not be immediately visible (see
illustration
not respond immediately to the heat for
the recommended exposure time.
- Young, soft-leaved plants are sensi-
tive to the treatment and afterwards
they are no longer viable.
- Hard-leaved grasses are very robust.
They have to be treated more fre-
quently.
- Older plants and plants with hard
leaves, such as thistles, have to be
treated more regularly at 1-2 week
intervals in order to successfully dry
them out.
be scorched for a longer exposure time
during treatment.
necessary. Heating them dries out the
leaves and any weeds die.
you will have to repeat treatments sev-
eral times in short periods for lasting
success. After this, longer treatment
repeat the treatment.
Assembly
Assembling the tool:
that it is not pinched by the extension
1
It is helpful to put the cable in a loop
so that it takes up less space.
tool and secure it with the two Phillips
screws supplied (see illustration
2
to put on. If necessary, check whether
installation.
Mounting the stand bracket:
hanging it in one of the two holes and
then placing it in the opposite hole on
(see illustration
3
Initial start-up
may escape. The smoke is caused by bind-
ers which are removed from the insulating
use.
To achieve a quick discharge, the tool
should be placed on the standing bracket
(
Be sure to ventilate the working environ-
mentduringrstuse.Ifthesmoke/odour
is too strong, move the initial start-up to
outside!
To Next Page
Loading...