20 GB/IE/NI
Adjusting the speed
(Fig. K)
NOTES
u Adjust the speed, before you apply the
product to the surface.
u Use a low speed for rough sanding. Use a
high speed for smooth finishing.
Increasing speed: Press the + button [].
Reducing speed: Press the – button [].
NOTE
u After you switch off the product, the
sanding pad [2] keeps on rotating for a
short while. Wait until the sanding pad
stops rotating, before you put the product
aside.
Removing and attaching the
detachable front guard cover
(Fig. L)
NOTE
u You can remove the detachable front guard
cover [3], if you want to apply the product
closer to the wall/ceiling.
Removing: Slightly press down the front
guard cover lock [4].
Pull the detachable front guard cover [3] off
the sanding guard [1].
Attaching: Reattach the detachable front
guard cover [3] to the sanding guard [1].
The front guard cover lock [4] must click into
place.
Switching the LED working
lamp on and off
(Fig. M)
Switching on: Press the LED working lamp
switch [] down into the I position.
Switching off: Press the LED working lamp
switch [] down into the O position.
Rotating and tilting the motor
housing
(Fig. N, O)
NOTE
u By rotating and tilting the motor housing [5]
you can maximise the accessibility to the
working surface. This allows the sanding
pad [2] to follow the contours of the
working surface.
You can rotate the motor housing [5] to the
left and right by up to 30°.
You can tilt the motor housing [5] to the front
by up to 30°.
You can tilt the motor housing [5] to the back
by up to 90°.
Working instructions
Select and attach a sanding paper [].
Switch on the product and adjust the speed.
Wait until the product has reached the set
speed.
Hold the sanding pad [2] parallel to the
working surface. Touch the working surface
with the brush edge [7].
Apply some pressure so that the sanding
paper [] touches the working surface.
To Next Page