21
NI CYIEGB
Troubleshooting
Switch off the tool and remove the battery before you service the
tool. Risk of electric shock!
Problems Possible Cause Error correction
Device doesn‘t start
On/off switch (
5) may be
defective
Repair by Customer Care
Engine faulty
Grinding tool does
not move although
the engine is run-
ning
Clamping screw is loose
Tighten clamping screw (see
„Changing disc“)
Workpiece, remaining work-
pieces or remaining grinding
tools block drive
Remove blockages
Engine is slower
and stops
Device is overloaded through
workpiece
Reduce pressure on grinding tool
Workpiece unsuitable
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
Clamping screw is loose
Tighten clamping screw (see
„Changing disc“)
Cutting/grinding disc is
defective
Change grinding disc
Replacement parts / Accessories
Spare parts and accessories can be obtained at
www.grizzly-service.eu
If you do not have internet access, please contact the Service Centre via telephone
(see “Service-Center” page 20). Please have the order number mentioned below ready.
Item. Description .............................................................Order-No.
2 Cutting disc .......................................................................30211074
17+3 Clamping ange with clamping screw ..................................91100646
To Next Page
Loading...
Need help?
General