6
GB IE NI CY
Levels of noise and vibration were deter-
mined according to the norms and regula-
tions in the declaration of conformity.
The vibration emission value has been
measured according to a standardised test-
ing method and may be used for compari-
son with another electric tool.
The indicated vibration emission value may
also be used for an introductory assess-
ment of the exposure.
Warning:
The vibration emission value whilst
actually using the electrical tool
may vary from the given values in-
dependently of the type and way in
which the electric tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).
Notes on safety
Caution! When using
power tools, observe the
following basic safety
measures for the prevention
of electric shocks and the
risk of injury and re.
Please read all these instruc-
tions before using this elec-
tric tool and please keep
the safety instructions.
Symbols and icons
Symbols on the device:
Warning!
Read the manual!
Wear ear protection
Wear eye protection
Wear breathing protection
The device is part
of the Parkside
X12VTEAM series
Risk of cuts!
Wear cut-resistant gloves
Direction of rotation
Electrical machines do
not belong with domestic
waste
Other symbols on the
cutting disc:
Do not use for side grinding
Do not use for wet grinding
Do not use defective discs
Wear safety shoes
Symbols in the manual
Warning symbols
with information on
damage and injury
prevention.
To Next Page
Loading...
Need help?
General