Parkside PWT 11 A1 - Initial Setup and First Use; Battery Installation and Replacement

PWT 11 A1
GB
│
IE
│
7 ■
First use
Inserting/replacing the batteries
The appliance is operated with four 1.5 V AA/Mignon/LR6 batteries
(included in delivery).
♦ If necessary, disconnect the appliance from the water connection
and switch it off.
♦ Slide the protective cover q downwards and remove it (see Fig. 1).
♦ Lift the tab and remove the battery compartment cover 0 (see Fig. 2).
♦ Remove the depleted batteries, if necessary.
♦ Insert four 1.5 V AA/Mignon/LR6 batteries into the battery com-
partment. Make sure that the polarity is correct, as indicated in the
battery compartment. The LED of the motion sensor 9 lights up red
briefly. The appliance is now ready for use.
♦ Place the battery compartment cover 0 back on the battery com-
partment. Make sure that the sealing ring is firmly seated (see Fig. 3).
♦ Slide the protective cover q over the battery compartment (see
Fig. 4).
+
−
AA
+
−
AA
+
−
AA
+
−
AA
Fig. 1 Fig. 2 Fig. 3 Fig. 4
NOTE
► When the batteries are low, the LED of the motion sensor 9 flashes
red. The batteries should be changed as soon as possible.
IB_360872_PWT11A1_LB8.indb 7 04.02.2021 15:16:25