To Next PageTo Next PageHow to prevent a rough or wavy saw cut with my Parkside PZKS 2000 A1 Saw?
If the saw cut of your Parkside Saw is rough or wavy, it could be because the saw blade is dull or the tooth shape isn't appropriate for the material thickness. To address this, re-sharpen the saw blade and/or use a suitable saw blade.
Why is my Parkside PZKS 2000 A1 Saw motor making excessive noise?
If the motor of your Parkside Saw makes excessive noise, it could be due to damaged coils or a defective motor. It's recommended to arrange for a specialist to inspect the motor.
What causes a workpiece to pull away or splinter when using a Parkside PZKS 2000 A1?
If the workpiece pulls away and/or splinters when using your Parkside Saw, it may be due to excessive cutting pressure or an unsuitable saw blade. To resolve this, insert a suitable saw blade.
Why is the saw cut rough or wavy with my Parkside PZKS 2000 A1?
If your Parkside Saw's cut is rough or wavy, the saw blade may be dull, or the tooth shape might not be right for the material's thickness. Try re-sharpening the saw blade or using a more suitable blade.
What to do if the Parkside PZKS 2000 A1 Saw motor does not reach its full power?
If your Parkside Saw's motor isn't reaching its full power, the circuits in the network might be overloaded by other equipment. Avoid using other equipment or motors on the same circuit.
General