7 English
Internet
Sharing a phone 3G connection via USB
Note: Refer to the compa tibility page of our website to check if
your phone a llows 3G connection sharing via U SB a nd to
consult the corresponding procedure :
www.parrot.com/uk/
compatibility
.
1. Make sure the USB sharing option is activated. To
do so, select Settings > Network > USB sharing >
Activate.
2. Make sure that your phone’s keypad is unlocked
and connect the phone to the Parrot ASTEROID
Classic using a USB cable/micro-USB and the USB
extension cable provided with the Parrot ASTEROID
Classic.
Note : This connection a lso ena bles you to recharge your
phone’s battery.
3. Select your APN (Access Point Name) from the
suggested list if necessary.
Note : If your APN is not in the list, you can a dd it by selecting
Settings > Network > USB sha ring > Configura tion.
Sharing a phone 3G connection via Bluetooth
Note: Refer to the compa tibility page of our website to check if
your phone a llows 3G connection sharing via Bluetooth and to
consult the corresponding procedure :
www.parrot.com/uk/
compatibility
.
If you have a phone that supports the DUN (Dial-Up
Networking) or PAN (Personal Area Network) Bluetooth
profiles, the Bluetooth connecting your phone to the Parrot
ASTEROID Classic will allow for sharing of the phone's 3G
connection.
1. Make sure the Bluetooth sharing option is
activated. To do so, select Settings > Network >
Bluetooth sharing > Activate.
2. Allow connection sharing on your phone. This
procedure will vary according to your phone
model.
3. Connect your phone to the Parrot ASTEROID
Classic via Bluetooth.
4. If necessary, select your APN (Access Point Name)
from the suggested list.
Note : If your APN is not in the list, you can a dd it by selecting
Settings > Network > Bluetooth sharing > Configura tion.
Connecting a 3G / 4G key
Note: Refer to the compatibility section of the Parrot
ASTEROID Classic on our website to get the list of 3G / 4G keys
compatible with the Parrot ASTEROID Classic:
www.parrot.com/fr/compatibility/3g
.
Note: To guara ntee an optimal reception qua lity we
recommend you do not connect your internet U SB key 3G on
the Parrot ASTEROID Cla ssic directly : use the U SB cable to
install your device on the dashboard (or any other open area ).
1. Connect a 3G key to the Parrot ASTEROID Classic
using a USB cable.
2. Select OK to activate the 3G connection.
3. Enter your PIN code using the jog wheel (if
required), then select OK.
4. Select your APN (Access Point Name) from the
suggested list. This information is available in the
documentation provided with your 3G key.
Note: If your APN is not in the list, you ca n a dd it by selecting
Settings > Network > USB modem > Configura tion.
5. Wait approximately 30 seconds until the
connection is established.
To Next Page
Loading...
Need help?
General
