Parrot CK3100 Series - Option 2: Via AC Control (Manual AC)

This sheet is designed to help you with the installation of a Parrot product and is purely for information. Any installation performed in
compliance with the instructions appearing in this document is done under the sole responsibility of the installer, who is entirely responsible
for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA RCS PARIS 394 149 496. May not be reproduced without the
authorisation of Parrot SA. Pictures for information only.
POLO V
Finding an ACC wire
Make a pigtail connection on the
large gauge red/white cable
behind the air conditioning
control. Then connect a blue
cable using a jumper or by
soldering, and insulate using
adhesive tape (using a
multimeter, check that the +12V
supply is indeed controlled by the
ignition key).
Connect the +IGN wire using a
male round terminal to the blue
wire of the adapter in front of the
fuse holder.
1 2
Option 2: Via the air conditioning control (manual air
conditioning)