Parrot CK3000 User Manual

106 pages

To Next Page

ENGLISH

Thank you for purchasing Parrot CK3000, the hands-free kit with voice recognition equipped with Bluetooth® radio

technology.

Parrot CK3000 offers you the following functions:

Wireless radio connection with your telephone via Bluetooth®;

Full duplex hands-free conversation with echo cancellation and DSP;

Background noise reduction;

Voice recognition for up to 300 voice tags *;

Automatic synchronization of your telephone directory *;

Automatic mute of the car radio and connection to the speakers of your vehicle;

Pairing of up to 3 phones.

* Only with specific phones

INSTALLATION

If your CK3000 was installed by a professional, go directly to the next section, the Connection Phase.

The CK3000 consists of an electronic control box, a microphone, a keypad with “On” and “Off” buttons and two ISO car

radio connection harnesses.

Electronic control box:

Do not install the control box close to the heater or the air-conditioning system.

Protect the control box from direct sunlight. Avoid enclosing the unit inside of metal components - this will adversely affect

the quality of the Bluetooth® connection.

Microphone:

The microphone should be directed towards the driver and should preferably be installed in between the visor and rear-view

mirror.

Keypad:

We recommend you install Keypad in an easily accessible place, preferably on a clean, flat surface.

Connect the Keypad to the connector provided on the mute cable.

Check that the red and green lights come on and go off according to the position of the ignition key.

Connecting the mute cable and power cable:

The mute cable is equipped with black ISO connectors.

The power cable is equipped with gray ISO connectors.

Car radio with ISO sockets:

Disconnect the car radio speaker and power harnesses.

Connect the mute cable and power cable female connectors to the car radio.

Connect the vehicle speaker and power harnesses to the male connectors.

If the car radio has a Mute input, connect the yellow wire on the mute cable to one of the "Mute in" inputs 1, 2 or 3.

Consult the car radio manual to determine the location of the mute input.

Car radio without ISO sockets:

A specific adapter harness for the vehicle (not supplied) may be used

If you do not have an adapter, connect the wires one by one.

If the car radio has a "mute" input, connect the yellow wire on the mute cable to it.

Important:

The red wire on the power cable must be connected to the 12V

permanent, the orange wire to the 12V switched and the black wire to

the ground.

Check the electrical diagram of the car radio's ISO power harness.

On some vehicles, the positions of the red and orange wires must be

inverted. It is done by simply inverting the fuse holders.

Do not connect the orange wire to the 12V permanent, you run the risk

of discharging the battery of the vehicle.

Other manuals for Parrot CK3000

Manual8 pages

Questions and Answers:

J
Jason LeonJul 31, 2025
What to do if my telephone is not detected by Parrot Automobile Electronics?
- P
  pittmandavidJul 31, 2025
  If your telephone is not detected by your Parrot Automobile Electronics, repeat the connection phase.
J
Joan NelsonAug 13, 2025
How to fix telephone not detecting Parrot Automobile Electronics hands-free kit?
- D
  Daniel JonesAug 13, 2025
  If your telephone does not detect the Parrot hands-free kit, switch your telephone off and then switch it back on again. Also, check that the Bluetooth connection of your telephone is enabled.

Parrot CK3000 Specifications

General

Bluetooth Version	2.0
Voice Recognition	Yes
Maximum Range	10 meters
Microphone	External
Compatibility	Bluetooth-enabled phones
Bluetooth Profiles	HFP
Type	Bluetooth car kit
Additional Features	Noise cancellation