18
PAIRING WITH SPV E200
When you switch on for the first time or when you perform a new installation, you need to pair your telephone and your
Parrot CK3000. Once this is done, connection between your telephone and your hands-free kit will take place automatically
as soon as the two devices are less than a few meters apart. A 'beep' will be heard, indicating that connection is
established.
Procedure:
IMPORTANT: The CK3000 hands-free kit is only operational when the vehicle's ignition is switched on.
With your telephone switched on; switch on your vehicle's ignition. The two indicators that light on the buttons show that
your hands-free kit is powered up. Then perform the following sequence using your telephone.
Call up the Startup menu, then choose Parameters, then Bluetooth.
Bluetooth must be set to the Active mode, then call up Menu, Linked devices.
From the Linked devices screen, call up Menu, then choose New.
Wait while your telephone detects your Parrot CK3000 kit.
Choose your "Parrot CK v…" kit using Add.
Enter the code 1234, then End. Validate this connection by choosing Yes from the confirmation screen.
Now you are linked to the kit.
COMMUNICATING
Initiating a call:
Enter the number to call using the telephone key pad.
Answering an incoming call:
Press the green button on the keypad.
Managing a second call:
The call waiting function is managed from the telephone.
The second call is indicated by beeps through the speakers.
To answer the second call, press Accept.
To switch between the two calls, choose Exchange from the Menu.
To end a call, choose End from the Menu.
Clearing the memory:
Press the red and green buttons simultaneously and at length.
IMPORTANT:
1 – The telephone does not control the volume setting.
2 – The telephone does not support voice recognition.
3 – There is no way to change to discrete mode.
To Next Page
Loading...
Need help?
General
