Pull the rope slowly until resistance is felt. 6.
Otherwise some corrosion may begin almost immediately.
1. Thoroughly wash away
7. Give a strong pull straight out to crank and start the engine. Repeat it necessary.
5.3 Treatment of submerged motor
If the outboard is submerged, immediately take it to a PARSUN dealer.
contaminants with fresh water.
2. Remove the spark plug(s), then face the spark plug hole downward to allow any mud, or
3. Fill the sump with fresh engine oil.
contaminants to drain.
4. Feed engine fogging oil or engine io l through the carburetor(s) and spark plug holes while starting the
engine.
44
To Next Page
Loading...
Need help?
General
