Partner RP-300 - Printing and Cutting Positions

TITLE : RP-300/310
Page -9 -
1.7 Printing and Cutting Positions
e
nter of the
p
rint dotline
o-cutter blade
p
osition
Manual-cutter position
[Units: mm(Al the numeric values are typical.)]
Appro *12.6
Paper feed direction
Appro *
30.5
Figure 1.7.1 Printing and Cutting Positions
NOTE: Numeric values used here are center values to be used in designing. The values may
vary slightly as a result of paper slack or variations in the paper. Take this into account
when setting the cutting position of the auto cutter.