Partner RP-300 - Paper Roll Supply Device; Paper Specification

TITLE : RP-300/310
Page -4 -
1.4 Paper Roll Supply Device
1) Supply method: Drop-in paper roll
2) Near-end sensor:
a) Detection method: Photo Reflector
b) Paper roll spool diameter: Inside: 12mm(.47″ )
Outside: 18mm(.71″)
c) Near-end adjustment: Adjusting screw
d) Remaining amount: Fixed position #1 (approximately
23mm(0.9″ )) #2 (approximately
27mm(1.06″ ))
NOTE: You can use a command to stop printing upon detection of a paper
near-end.
1.5 Paper Specification
1) Paper type: Specified thermal paper
2) Form: Paper roll
3) Paper width:
(82.5mm paper width model)
82 ±0.5mm (3.23" ±0.02")
(80mm paper width model)
79.5 ±0.5mm (3.13" ±0.02")
(60mm paper width model)
59.5 ±0.5mm (2.34" ±0.02")
(58mm paper width model)
57.5 ±0.5mm (2.26" ±0.02")
4) Paper roll size: Roll diameter : Maximum 83mm
Take-up paper roll width:
80 ± 0.5, 1.0mm(3.15"±0.020", 0.04")
5) Paper roll spool diameter: Inside: 12mm(.47")
Outside: 18mm(.71")
NOTE: Paper must not be pasted to the paper roll spool.