TITLE : RP-300/310
Page -70 -
[Details for①and②]
·This command is effective only processed at the beginning of a line.
[Note for ①]
·Only the partial cut is available; there is no full cut.
[Details for②]
·When n = 0, the printer feeds the paper to the cutting position and cuts it.
·When n ≠ 0, the printer feeds the paper to (cutting position + [ n ´
vertical motion unit
]) and cuts it.
·The horizontal and vertical motion unit are specified by GS P.
·The paper feed amount is calculated using the vertical motion unit (
y).
However, the value cannot be less than the minimum horizontal
movement amount, and it must be in even units of the minimum
horizontal movement amount.
GS W
nL nH
[Name] Set printing area width
[Format] ASCII GS W
nL nH
Hex 1D 57
nL nH
Decimal 29 87
nL nH
[Range] 0 ≤
nL
≤ 255
0 ≤
nH
≤ 255
[Description] Sets the printing area width to the area specified by
nL
and
nH.
·The printing area width is set to [(
nL
+
nH
x 256) x horizontal motion
unit]].
Printable area
Left margin Printing area width
[Details] ·This command is effective only processed at the beginning of the line.
To Next Page
Loading...
