How to fix Paslode Nail Gun when fasteners won't drive completely into wood?
If your Paslode Nail Gun is not driving fasteners completely into the wood, you can adjust the work contacting element (retract length) and increase the air pressure, but do not exceed 120 psi.
What to do if my Paslode Nail Gun skips and doesn't drive fasteners?
If your Paslode Nail Gun skips during operation, and no fasteners are driven from time to time, you should: 1. Check the magazine for proper fasteners. 2. Ensure the magazine follower slides freely, cleaning it as needed to remove debris. 3. Verify that you're using the correct fasteners that meet Paslode specifications. 4. Increase air flow to the tool by using larger air lines (3/8 ID minimum). 5. Adjust the work contacting element, if available.
What to do if Paslode Nail Gun operates but doesn't drive fasteners?
If your Paslode Nail Gun operates but doesn't drive any fasteners, first check the magazine to ensure it contains the proper fasteners. Make sure the fasteners slide freely without pressure from the follower. Also, increase the air pressure, but do not exceed 120 psi.
What to do if Paslode Nail Gun doesn't drive fasteners fully at faster speeds?
If your Paslode Nail Gun drives fasteners properly during normal operation, but won't drive them fully at faster speeds, increase the air flow to the tool by using larger air lines (3/8 inch ID minimum).
General| Power Source | Fuel cell and battery |
|---|---|
| Fastener Type | Nails |
| Fuel Cell Type | Paslode fuel cell |
| Nail Length | 2 in. - 3-1/2 in. |
| Nail Type | Round head |
| Battery Type | Lithium-ion battery |
To Next Page