EasyManua.ls Logo

Paso CMDS Series - Storing Tuner Channels; Recalling Stored Tuner Channels

Paso CMDS Series
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERIE CMDS
12
4.3.1 Memorizzazione dei canali
Il sintonizzatore dispone di 10 posizioni di memoria per la banda FM e di 5
per la banda AM. Per memorizzare una stazione radio precedentemente
sintonizzata, occorre operare come segue:
1. Premere il tasto ME;
2. Premere il tasto MEMORY (M1, M2...) relativo al numero progressivo
che si vuole attribuire al programma.
Una volta memorizzata una stazione radio, comparirà, a lato della
frequenza visualizzata sul display, il numero della posizione di memoria ad
essa associata.
Per memorizzare i canali da 6 a 10, occorrerà invece:
1. Premere il tasto ME;
2. Premere il tasto SHIFT;
3. Premere il tasto MEMORY (M1, M2...) relativo al numero progressivo
che si vuole attribuire (5 + 1...).
4.3.2 Richiamo dei canali memorizzati
Per richiamare una stazione memorizzata nei canali da 1 a 5 è sufficiente
premere il tasto relativo alla posizione desiderata; per richiamare una
stazione memorizzata nei canali da 6 a 10 è necessario invece far
precedere la pressione del tasto MEMORY da quella del tasto SHIFT.
POS. 1 POS. 3
POS. 6 POS. 10
4.3.1 Storing channels
The tuner has 10 storage cells for the FM band and 5 for the AM band.
To store a previously tuned radio station, you must proceed as follows:
1. Press the ME key;
2. Press the MEMORY key (M1, M2, etc. referred to the progressive
number you wish to assign to the program.
Once a radio station has been stored, the number of the memory cell
associated with it will appear next to the frequency shown on the display.
To store channels 6 to 10, on the other hand, it is necessary to:
1. Press the ME key;
2. Press the SHIFT key;
3 Press the MEMORY key (M1, M2, etc. referred to the progressive
number you wish to assign (5 + 1...).
4.3.2 Calling up the stored channels
To call up one of the stations stored in channels 1 to 5, it is sufficient to
press the key corresponding to the required position.
To call up one of the stations stored in channels 6 to 10, on the other
hand, it is necessary to press the SHIFT key before pressing the
MEMORY key.
USO DELL’APPARECCHIO USING THE EQUIPMENT4
11-626.pmd 06/10/2005, 15.4012

Table of Contents

Other manuals for Paso CMDS Series