DS350GM - BOOM CONTROL EXTENSION RT 865BXL 2
031-300-190-047 Rev0 02/17/1999
WARNING
The DS 350 load moment indicator (LMI) with boom control extension is an operational
aid that warns the crane operator when approaching an overload condition, a two block
condition and an out of boom sequence condition.
Prior to operating the crane, the operator must carefully and thoroughly read and
understand the information provided by the crane and load moment indicator
manufacturer.
The responsibility for safe crane operation shall remain with the crane operator who
shall ensure that all warnings and instructions supplied are fully understood and
observed.
It still remains the operator’s responsibility to verify the operation and to select the
correct mode during crane operations.
The DS 350 Modular with boom control extension is not, and shall not, be a substitute
for good operator judgment, experience and use of accepted safe crane operating
procedure
Proper functioning depends upon proper daily inspection and observance of the
operating instructions provided with the crane and load moment indicator.
The manual mode is a rigging mode. Lifting loads in manual mode is prohibited.
Should an out of sequence condition occur, the crane operator is responsible to select
manual mode to return the sections into sequence before continuing the lift.
REFERENCE MATERIAL
Document PAT- Part number Grove- Part number
Parts & Installation Manual 031-300-150-713 9-333-103628
Operator’s Handbook 50\350\19_1319e.doc
To Next Page
Loading...
