Maverick Boat Group
3207 Industrial 29th St. • Fort Pierce, Florida 34946
(772)-465-0631 • Pathfinderboats.com
If the bilge pump still does not turn on, it likely needs to be replaced. It is not
recommended to use your boat if the bilge pump and/or float switch are not functioning
properly.
Systems
Ball Valves
Ball valves can be used to serve several purposes. They allow
seawater to enter the boat, in the case of livewells, and they also
act as a safeguard to stop water from entering. To tell which
position a ball valve is in, open or closed, look at the valve and
determine the direction of flow. When the ball valve handle is in
the same position as the direction of flow, the valve is in the
“OPEN” position. When the ball valve handle appears to cross the
direction of flow, the valve is in the “CLOSED” position.
exhausts any air that may cause the pump to air lock. It is normal to
see mist or spray escaping while the pump is running as it is still
To Next Page
Loading...
