Battery Switch and Breaker Panel
Battery Switch and Breaker Panel
The battery switch and breaker panel are located
inside the glovebox on the aft side of the console. The
top 80-amp breaker is the main power for the boat,
which feeds the switch panel on the helm and its
associated accessories along with engine power. The
remaining breakers are labeled with the
corresponding component and amperage. When the
boat is not in use, it is recommended to leave the
battery switch in the off, “0’, position to ensure that the main battery is not drained over
the long term by minor current flows.
In the 2200TRS the trolling motor batteries are located inside the console and the
switch for the system is located on the battery switch panel.
Battery Access
The cranking battery is located inside the console. To access the batterie, open the
console doors on the front side of the console.
Ladder & Props
Stainless Boarding Ladder
The 2200TRS comes with the Swim/Dive Platform mounted in the stern of the boat.
This platform provides for an easier and safer entry and exit from the boat. To operate
the platform simply lift the metal ladder from the platform, extend the ladder to its full
length, and let the ladder fall into the water. The ladder is the designed method for
unassisted reboarding should the situation arise where it is necessary.